Bliss 3015 Transfer Press built by Ferracute w .223 5.56 projectile tooling

<p>Ferracute SG-53 Transfer Press built to the Blisss 3015 Prints during WWII.<br/>* Very nice press in good condition. Just Cleaned.<br/>* Press appears to be complete and working.<br/>* Back Cams, Lifters and Probe Assemblies<br/>* Ross Duel Solenoid Safety Valve - Newer<br/>* Cup / Tube in feed track assembly<br/>* Minster Air Clutch &amp; Brake! Serial Number 12158<br/>* Minster Clutch Brake Control Package<br/>* 480 Volt - current set up. Could be changed to 240V with some electrical work.<br/>* Inch, Single, Continuous, Stop selector switch<br/>* Decent 20 year old press controls<br/>* Press was running .223/5.56 Cases in its previous life. Some tooling is in the press.<br/>- All the dies are in the bed with kick ups<br/>- Punch holders are in the ram and a couple of punches<br/>- Feed of drawn tubes included<br/>- All the transfer fingers included<br/>- Looks like 80% of the tooling is in the press<br/>- Engineering, Tooling &amp; Development will be required!<br/>* Centro-Matic oil lube system on press with dozens of oil lines to all moving surfaces<br/>- System needs to be checked out, repaired here and there and tested!<br/>* Press looks to be in good old working order. Needs a smart press guy to peel off some old shit and install new wires, controls, lube lines and love as necessary. A coat of paint would not hurt also. Or rebuild the press completely if you run and love these regularly.<br/>* Can&#39;t find serial number. Don&#39;t know where to look either. If you like these and need to know, tell us where to look and we will send serial #.<br/>* More photos available. These websites won&#39;t load more than 12 pics.</p>