Ferracute SG53 Transfer Press Bliss 3015 with 5" Stroke Minster Clutch Brake

Ferracute SG-53 Transfer Press built to the Blisss 3015 Prints during WWII. * Very nice press in good condition. Just Cleaned. * Press appears to be complete and working. * Back Cams, Lifters and Probe Assemblies * Ross Duel Solenoid Safety Valve - Newer * Cup / Tube in feed track assembly * Minster Air Clutch & Brake! Serial Number 12158 * Minster Clutch Brake Control Package * 480 Volt - current set up. Could be changed to 240V with some electrical work. * Inch, Single, Continuous, Stop selector switch * Decent 20 year old press controls * Press was running .223/5.56 Cases in its previous life. Some tooling is in the press. - All the dies are in the bed with kick ups - Punch holders are in the ram and a couple of punches - Feed of drawn tubes included - All the transfer fingers included - Looks like 80% of the tooling is in the press - Engineering, Tooling & Development will be required! * Centro-Matic oil lube system on press with dozens of oil lines to all moving surfaces - System needs to be checked out, repaired here and there and tested! * Press looks to be in good old working order. Needs a smart press guy to peel off some old shit and install new wires, controls, lube lines and love as necessary. A coat of paint would not hurt also. Or rebuild the press completely if you run and love these regularly. * Can't find serial number. Don't know where to look either. If you like these and need to know, tell us where to look and we will send serial #. * More photos available. These websites won't load more than 12 pics.